Generation Specific > 2nd Generation Specific

OMP

(1/3) > >>

FCSTARK:
I am deleting the oil injection and I am trying to block off the oil injectors. Does anyone know what size bolts are needed to block off the oil injectors?

murz:
I'm almost positive it's M10x1.25x10 to 20mm. Make sure you use crush washers to seal.

FCSTARK:
Thanks! Its one of the last things I need to get before it goes all back together

~Groll69~:
Can I get your OMP injectors if you don't want them?  I am especially interested in the primary injectors.

FCSTARK:
Yea I just have to go through and find them. I had to use the banjo bolts for the primaries because I didnt have a small enough bolt size to block them off without using the banjo bolt as a spacer. But otherwise they are still in good condition

Navigation

[0] Message Index

[#] Next page