Michigan Rotary Club
New Members Help and Forum => Lounge => : fidelity101 March 04, 2014, 08:42:17 AM
-
(http://picoolio.net/images/2014/03/04/20140302173034.jpg)
(http://picoolio.net/images/2014/03/04/20140302173122.jpg)
(http://picoolio.net/images/2014/03/04/20140303215507.jpg)
(http://picoolio.net/images/2014/03/04/20140303215517.jpg)
Afew concerns:
1. I overported this in efforts to run without inserts.
2. if I decide to the use the inserts there is a gap between the port opening and the exhaust insert. Would that be worse than running without insert?
3. The scratches/chrome flaking. The chrome flaking is in spec and that is the worst area out of the pair of housings. I can barely catch my finger nail on it but I'm sure its more than .0002" or whatever the spec is.
I'm tempted to use these, would you?
Notes:
This is a half bridge engine with huge ports, 4 port t2 end plates, s5 NA center iron.
I put a stock NA housing with stock insert next to this next to a stock NA housing with t2 insert to be able to see the difference.
-
I say give them a shot.
-
If you were to, would you run with or without inserts? with the insert in you can see where it hangs above the floor of the ported portion on the housing...
or I need to hack up the insert to accomodate that new shape.
-
I would run without the insert personally. it will take away from some of the low end power. but the setup is better for turboing without the inserts.
-
I sent these photos to other rotards and I got some good feedback.
Looks like I'm gonna assemble a rotary either saturday or sunday, anyone wanna join and have a few brews?
-
Well saturday was my birthday and as gift from Will, we started the assembly of my engine. We started media blasting a rotor and front iron and painted it. How did the build go yesterday?
-
It went together the following friday, some other issues got in the way. All in all a bit smooth but last time I did this I prepped the rotors 100% the day before so all I had to do was drop them in. It made for quite the long build.
I also got carried away on the hylomar this time, I may want to use a smaller brush and apply it next time lol.
Just started porting my t2 block for my NA streetport build since the rx8 trans came in last week :)